High Quality Jkd5056S Digital Stepper Motor Driver Controller, Jkd5056S Digital Two-Phase Stepper Driver, High Quality Step Motor Driver Approved For Ce Certification Suppliers in China

Home > Products > Driver Motor > Stepper Motor Driver > 3AXIS and 4AXIS TB6560 stepper motor driver

3AXIS and 4AXIS TB6560 stepper motor driver

Basic Info

Model No.: TB6560

Product Description

 

 

 

         

 

 

Product Features:

Toshiba TB6560AHQ chip - High power, maximum 3.5A drive current chipset

1-1/16 microstep setting - Higher accuracy and smoother operation than standard 1, 1/2 step!

Adjustable drive current settings for each axis - 25%,50%,75%,100% of full current can be set for different stepper motors

Overload, over-current and over-temperature safety - Full protection for your computer and peripheral equipment

On board current switching - Power output can be set according to specific user requirement  

Full closed-type optical isolation to protect the user's computer and equipment

Relay spindle interface - Outputs Max. 36V 7.5A for spindle motors or coolant pump (only one device can be powered by this output!)

4 channel inputs interface- Can be used for XYZ limit and emergency stop  

Professional design - Two stage signal processing with super anti-jamming

Bipolar constant current chopper drive with non-resonant region - Controls motors smoothly through range without creep effect  

Four control inputs (divided into pairs of knives) - Allows setting of limit and emergency stop

Universal architecture - Supports most parallel software MACH3, KCAM4, EMC2 etc!

Dip settings:

Current Setting

1

2

Decay Mode Settings

3

4

MicroStep Settings

5

6

100%

ON

ON

FAST

ON

ON

1

ON

ON

75%

OFF

ON

25%

ON

OFF

1/2

ON

OFF

50%

ON

OFF

50%

OFF

ON

1/8

OFF

OFF

25%

OFF

OFF

SLOW

OFF

OFF

1/16

OFF

ON

* Important Notes:

Power Supply DC 12-36V (not included)
*Voltage Selection:
12-16V DC power supply for Nema 17 stepper motors
16-24V DC power supply for Nema 23 stepper motors
24-36V DC power supply for Nema 34 stepper motors
(High voltage will burn up the chips or stepper motors!!!)
*Amperage Selection:
Output current of the power supply can be calculated by the following expressions:
Output current = Rated current of your stepper motors * quantity + 2A
(For example, if you want to drive 3 * 3A Nema 23 stepper motors, theoretically 24V 11A DC power supply is recommended, but higher power such as 24V 15A also will be good.
If you are not sure about the selection of power supply, please feel free to contact us for help) 

The power output of 12V shall be applied to the radiator fan of 12V

Driver output compatible with 2 or 4 phase, 4,6 or 8 lead stepper motors, 3A max.

Suitable for unipolar or bipolar stepper motors.

Voltage regulated spindle speed controlled by parallel interface as function of supply voltage.


 

 

Other products:

High torque 1.8 degree 60mm NEMA24 2 Phase Stepper Motor

 

 

 

Product Categories : Driver Motor > Stepper Motor Driver

Email to this supplier
  • *Subject:
  • To:

  • *Messages:
    Your message must be between 20-8000 characters